How to Setup Grabit

Posted on 05 November 2014 01:48 PM

When you start up Grabit for the first time the following setup wizard will appear:

Hit next to continue.

The next box asks for your providers hostname in the case of NextGenNews its this is for all our ports.

The next box ask for your username and password you can find this in your email you received from us, make sure you enter it correctly keep mind of the lower and upper-case.

That is it your good to go!
However if you want to increase your default connections keep reading.




When grabit opens up to change server settings right click on your server name ( and select "Server properties"

Here you can change your password as well as other settings take note of the bottom slider here you can change the amount of connection made to our servers.
We recommend to set this always slightly less then your maximum connections. So if you have 30 then set this to 28.


As a last tip make sure in the bottom right corner the proper amount of thread's are in use.

(2 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).

South African PayFast Payments Accepted International PayPal Payments Accepted 

 ©2017 NextGenNews - All rights reserved.


[ Home ]  [ Signup ]  [ Packages ]  [ Knowledge Base ]  [ NZB Verifier ]  [ Traceroute ]  [ Speed Test ]  [ System Status ]  [ Contact Us ]  [ Bulk & Reseller Services ]  [ DMCA Policy ]  [ Privacy Policy ]  [ Terms of Service